Free H12-211 Exam Braindumps certification guide Q A H12-211 Certification Overview Latest H12-211 PDF Dumps For more info visit: Huawei H12-211 Exam Reference NEW QUESTION 68 The requested node multicast address consists of the prefix FF02::1:FF00:0/104 and the last 24 bits of the unicast address. A. False B. True Answer: B NEW QUESTION 69 Judge: Run the Frame Relay port, MAP table is a logical interface [...]

Free H12-211 Exam Braindumps certification guide Q&A [Q68-Q86]

Share

Free H12-211 Exam Braindumps certification guide Q&A

H12-211 Certification Overview Latest H12-211 PDF Dumps


For more info visit:

Huawei H12-211 Exam Reference

 

NEW QUESTION 68
The requested node multicast address consists of the prefix FF02::1:FF00:0/104 and the last 24 bits of the unicast address.

  • A. False
  • B. True

Answer: B

 

NEW QUESTION 69
Judge: Run the Frame Relay port, MAP table is a logical interface corresponding to different logical interfaces with different MAP table.

  • A. False
  • B. True

Answer: B

 

NEW QUESTION 70
The network shown in the following figure requires the network where the host is located to access the Internet through Easy IP. Which of the following ACL5 should be used on the 00/0/3 interface of the muter?

  • A. ad number 2000 rub 5 permit source 10 0.13.1 0 0 0 0
  • B. act number 2000 rub 5 permit source 10 0.120 00 0255
  • C. ad number 2000 rub 5 permit source 100 12_1 00 00
  • D. act number 2000 rub 5 permit source 100_13 0 0 0 0 255

Answer: D

 

NEW QUESTION 71
Which of the following regarding Frame Relay DLCI are correct? (Choose three)

  • A. The same DLCI can be configured on different physical interfaces
  • B. DLCI is allocated by DTE
  • C. DLCI is locally significant
  • D. The range of DLCI value that can be used is from 16-1007

Answer: A,C,D

 

NEW QUESTION 72
The Routing table on R1 is as follows. Which of the following statement is true?
<Huawei>display ip routing-table
Route Flags: R - relay, D - download to fib
------------------------------------------------------------------------------
------------------------------------------------------------------------------ Routing Tables: Public Destinations : 7Routes : 7 Destination/Mask Proto Pre CostFlags NextHopInterface
10.0.2.2/32 Static 600D10.0.12.2Ethernet0/0/0
10.0.3.3/32 Static 600D10.0.2.2Ethernet0/0/0
10.0.12.0/24 Direct 00D10.0.12.1Ethernet0/0/0
10.0.12.1/32 Direct 0 0D 127.0.0.1Ethernet0/0/0

  • A. The Router forwards data packets with the destination IP address 10.0.3.3 through Eth0/0/0
  • B. The Router forwards data packets with the destination IP address 10.0.2.2 through Eth0/0/0
  • C. The Router forwards data packets with the destination IP address 10.0.12.1 through Eth0/0/0
  • D. The Next hope of route destined for 10.0.3.3/32 is not directly connected. As a result, the router does not forward data packets with the destination IP address 10.0.3.3

Answer: A,B,C

 

NEW QUESTION 73
Which of the following IPv6 extension headers can occur twice?

  • A. Hop-by-Hop Option header
  • B. Fragment extension header
  • C. Upper-layer header
  • D. Destination Option header

Answer: D

 

NEW QUESTION 74
According to the topology and configuration of interconnected interfaces of switches shown in the figure, the data frame tagged with VLAN 10 can be forwarded correctly between the two switches.

  • A. False
  • B. True

Answer: B

 

NEW QUESTION 75
As Shown in the figure, host A and host B cannot communicate with each other?

  • A. FALSE
  • B. TRUE

Answer: B

 

NEW QUESTION 76
When the host uses the stateless address autoconfiguration scheme to obtain an IPv6 address, the DNS server address information cannot be obtained.

  • A. False
  • B. True

Answer: B

 

NEW QUESTION 77
in the PPP, when the communication of both ends of the physical line activation is detected, it will not be available from link to link establishment phase transition stage, at this stage is mainly through the () link protocol configuration parameters

  • A. DHCP
  • B. IP
  • C. NCP
  • D. LCP

Answer: D

 

NEW QUESTION 78
Which of the following statements is true?

  • A. Switches work at the network layer.
  • B. Switches work at the physical layer.
  • C. Routers work at the physical layer.
  • D. Routers work at the network layer.

Answer: D

 

NEW QUESTION 79
Which fields are not included in the network layer header format?

  • A. TTL
  • B. Sequence Number
  • C. Source IPv4 Address
  • D. Destination IPv4 Address

Answer: B

 

NEW QUESTION 80
[Huawei]command-privilege level 3 view users save
Refer to the command output. what is the result of the shown command?

  • A. The command adjusts the save command of a user to privilege level 3.
  • B. The command adjusts the user view command privilege level to 3, and saves the configuration
  • C. The command adjusts the save command in the user view to privilege level 3
  • D. The command adjusts the privilege level of a user to 3, and saves the configuration.

Answer: C

 

NEW QUESTION 81
If the device access X.25 public packet networks, access to the X.25 interfaces must be in
accordance with the access requirements of service providers to set up an address, this address is called

  • A. IP address
  • B. X. 121 Addresses
  • C. MAC address
  • D. VPI / VCI identifier

Answer: B

 

NEW QUESTION 82
In the network shown below, which of the following commands can be entered in the router to enable Host A to ping through Host B? (Multiple Choice)

  • A. Router A : ip route-static 0.0.0.0 0.0.0 11.0.12.1 Router B : ip route-static 0.0.0.0 0.0.0 11.0.12.2
  • B. Router A : ip route-static 10.0.12.5 255.255.255.252 11.0.12.2 Router B : ip route-static
    10.0.12.1255.255.255.252 11.0.12.1
  • C. Router A : ip route-static 0.0.0.0 0.0.0 11.0.12.2 Router B : ip route-static 0.0.0.0 0.0.0 11.0.12.1
  • D. Router A : ip route-static 10.0.12.5 255.255.255.252 11.0.12.1 Router B : ip route-static 10.0.12.1
    255.255.255.252 11.0.12.2

Answer: B,C

 

NEW QUESTION 83
Source Destination Protocol Info
10.0.12.1 10.0.12.2 TCP 50190 > telnet [SYN] Seq=0 Win=8192 Len=0 MSS=1460
10.0.12.2 10.0.12.1 TCP telnet> 50190 [SYN, ACK] Seq=0 Ack=1 Win=8192 Len=0 MSS=1460
10.0.12.1 10.0.12.2 TCP 50190 > telnet [ACK] Seq=1 Ack=1 Win=8192 Len=0 Refer to the capture output.The administrator has captured three packets in the network. Which statement regarding the capured packets is incorrect?

  • A. 10.0.12.1 uses port 50190 to buid the telnet connection.
  • B. This packets represent a TCP three-way handshake process.
  • C. The three packets contain no application data.
  • D. 10.0.12.1 is the telnet server, while 10.0.12.2 is the telnet client.

Answer: D

 

NEW QUESTION 84
Refer to the graphic.

A web server in a private network is required to provide HTTP services to public users. The network administrator is required to configure NAT on RTA. Which configuration should be used?

  • A. [RTA-Gigabitethernet0/0/1]nat server protocol tcp global 202.10.10.1 www.inside 192.168.1.1 8080
  • B. [RTA-Serial0/0/1]nat server protocol tcp global 192.168.1.1 www.inside 202.10.10.1 8080
  • C. [RTA-Gigabitethernet0/0/1]nat server protocol tcp global 192.168.1.1 www.inside 202.10.10.1 8080
  • D. [RTA-Serial1/0/1]nat server protocol tcp global 202.10.10.1 www.inside 192.168.1.1 8080

Answer: D

 

NEW QUESTION 85
Which of the following features does HDLC have? (Multiple choice)

  • A. HDLC protocol does not support authentication
  • B. HDLC protocol supports point-to-point links
  • C. HDLC protocol does not support FP address negotiation.
  • D. HDLC protocol supports point-to-multipoint links

Answer: A,B,C

 

NEW QUESTION 86
......

The Best Huawei H12-211 Study Guides and Dumps of 2022: https://www.exam4free.com/H12-211-valid-dumps.html