2023 Updated Verified NSE7_SDW-7.0 Downloadable Printable Exam Dumps
The Ultimate Fortinet NSE7_SDW-7.0 Dumps PDF Review
Fortinet NSE7_SDW-7.0 exam covers a wide range of topics related to SD-WAN, including WAN architecture, deployment models, security, performance, and management. You will be tested on your ability to design, configure, and troubleshoot SD-WAN solutions using Fortinet's industry-leading products and technologies. NSE7_SDW-7.0 exam is intended for professionals who have a solid understanding of networking concepts and protocols, as well as hands-on experience with Fortinet's SD-WAN solutions.
Fortinet NSE 7 - SD-WAN 7.0 certification exam covers a wide range of topics, including SD-WAN deployment, configuration, and management, security policies, and troubleshooting. Candidates are expected to have a solid understanding of network security concepts and technologies, and hands-on experience with Fortinet's SD-WAN solution.
NEW QUESTION # 15
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set priority 10.
- B. Set cost 15.
- C. Set source 100.64.1.1.
- D. Set load-balance-mode source-ip-ip-based.
Answer: A,B
NEW QUESTION # 16
Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)
- A. update-source
- B. link-down-failover
- C. set-route-tag
- D. holdtime-timer
Answer: B,D
NEW QUESTION # 17
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- B. Firewall policy ID 1 has source NAT disabled.
- C. Changes have been made on firewall policy ID 1 on FortiGate.
- D. FortiGate has terminated the session after a change on policy ID 1.
Answer: C
NEW QUESTION # 18
Refer to the exhibit.
Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?
- A. exchange-interface-ip must be enabled.
- B. add-route must be disabled.
- C. mode-cfg must be enabled.
- D. type must be set to static.
Answer: B
Explanation:
Explanation
for using "non ike" routes (for example BGP/static and so on) you must do disable the add-route that inject automatically kernel route based on p2 selectors from the remote site from the SD-WAN_7.2_Study_Guide page 236
NEW QUESTION # 19
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )
- A. Traffic has matched none of the FortiGate policy routes.
- B. The FIB lookup resolved interface was the SD-WAN interface.
- C. Matched traffic failed RPF and was caught by the rule.
- D. An absolute SD-WAN rule was defined and matched traffic.
Answer: A,B
NEW QUESTION # 20
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows a site-to-site topology between two FortiGate devices: branch1_fgt and dc1_fgt. Exhibit B shows the system global and system settings configuration on dc1_fgt.
When branch1_client establishes a connection to dc1_host, the administrator observes that, on dc1_fgt, the reply traffic is routed over T_INET_0_0, even though T_INET_1_0 is the preferredmember in the matching SD-WAN rule.
Based on the information shown in the exhibits, what configuration change must be made on dc1_fgt so dc1_fgt routes the reply traffic over T_INET_1_0?
- A. Disable allow-subnet-overlap under config system settings.
- B. Disable tp-session-without-syn under config system settings.
- C. Enable auxiliary-session under config system settings.
- D. Enable snat-route-change under config system global.
Answer: C
Explanation:
Explanation
Controlling return path with auxiliary session When multiple incoming or outgoing interfaces are used in ECMP or for load balancing, changes to routing, incoming, or return traffic interfaces impacts how an existing sessions handles the traffic. Auxiliary sessions can be used to handle these changes to traffic patterns.https://docs.fortinet.com/document/fortigate/7.0.11/administration-guide/14295/controlling-return-path-
NEW QUESTION # 21
Refer to the exhibits.
Exhibit A
Exhibit B -
Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status.
The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule.
Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?
- A. The traffic will be routed over T_MPLS_0.
- B. The traffic will be load balanced across all three overlays.
- C. The traffic will be routed over T_INET_1_0.
- D. The traffic will be routed over T_INET_0_0.
Answer: A
NEW QUESTION # 22
Which two protocols in the IPsec suite are most used for authentication and encryption? (Choose two.)
- A. Secure Shell (SSH)
- B. Security Association (SA)
- C. Internet Key Exchange (IKE)
- D. Encapsulating Security Payload (ESP)
Answer: C,D
NEW QUESTION # 23
Which are two benefits of using CLI templates in FortiManager? (Choose two.)
- A. You can configure advanced CLI settings.
- B. You can reference meta fields.
- C. You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI template.
- D. You can configure interfaces as SD-WAN members without having to remove references first.
Answer: A,B
NEW QUESTION # 24 
Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)
- A. The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.
- B. The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.
- C. The traffic shaper drops packets if the bandwidth is less than 2500 KBps.
- D. The measured bandwidth is less than 100 KBps.
Answer: A,D
NEW QUESTION # 25
What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- B. It acts as a policy compliance entity to review all managed FortiGate devices.
- C. It improves SD-WAN performance on the managed FortiGate devices.
- D. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- E. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
Answer: D,E
NEW QUESTION # 26 
Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)
- A. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
- B. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
- C. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.
- D. London generates an IKE information message that contains the Toronto public IP address.
Answer: B,C
NEW QUESTION # 27
Refer to the exhibit.
Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change?
(Choose two.)
- A. FortiGate does not change existing sessions.
- B. FortiGate evaluates new sessions.
- C. FortiGate flushes all sessions.
- D. FortiGate terminates the old sessions.
Answer: A,B
Explanation:
Explanation
FortiGate not to flag existing impacted session as dirty by setting firewall-session-dirty to check new. The results is that FortiGate evaluates only new session against the new firewall policy.
NEW QUESTION # 28
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.
The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic.
Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?
- A. Destination internet service must be enabled on the traffic shaping policy.
- B. Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy.
- C. Web filtering must be enabled on the firewall policy.
- D. Application control must be enabled on the firewall policy.
Answer: D
NEW QUESTION # 29
......
Fortinet NSE7_SDW-7.0 exam is designed to test the knowledge and skills of IT professionals in the area of software-defined wide area networking (SD-WAN). NSE7_SDW-7.0 exam focuses on the Fortinet SD-WAN solution, version 7.0, and covers a wide range of topics related to SD-WAN, including deployment, management, troubleshooting, and security.
Achive your Success with Latest NSE7_SDW-7.0 Exam: https://www.exam4free.com/NSE7_SDW-7.0-valid-dumps.html
Achieve The Utmost Performance In NSE7_SDW-7.0 Exam Pass Guaranteed: https://drive.google.com/open?id=1iGx-txYbvsHWSERFqtqIEll6VrcJHg7b
