Get Fortinet NSE7_SDW-7.0 Dumps Questions Study Exam Guide May 25, 2024
NSE7_SDW-7.0 Premium Exam Engine - Download Free PDF Questions
NEW QUESTION # 20
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process?
(Choose two.)
- A. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- B. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
- C. A factory reset performed on FortiGate.
- D. The zero-touch provisioning process has completed internally, behind FortiGate.
- E. The FortiGate cloud key has not been added to the FortiGate cloud portal.
Answer: D,E
NEW QUESTION # 21
Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)
- A. link-down-failover
- B. holdtime-timer
- C. update-source
- D. set-route-tag
Answer: A,B
NEW QUESTION # 22
Refer to the exhibit.
Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)
- A. The number of simultaneous connections among all source IP addresses cannot exceed five connections.
- B. The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.
- C. The number of simultaneous connections allowed for each source IP address cannot exceed five connections.
- D. The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.
Answer: B,C
NEW QUESTION # 23
Which statement is correct about SD-WAN and ADVPN?
- A. You must use IKEv2 on IPsec tunnels.
- B. SD-WAN can steer traffic to ADVPN shortcuts, established over IPsec overlays, configured as SD-WAN members.
- C. Routes for ADVPN shortcuts must be manually configured.
- D. SD-WAN does not monitor the health and performance of ADVPN shortcuts.
Answer: B
NEW QUESTION # 24
Refer to the exhibits.
Exhibit A
Exhibit B
Exhibit A shows an SD-WAN event log and exhibit B shows the member status and the SD-WAN rule configuration.
Based on the exhibits, which two statements are correct? (Choose two.)
- A. Port2 has a lower latency than port1.
- B. Port2 has the highest member priority.
- C. FortiGate updated the outgoing interface list on the rule so it prefers port2.
- D. SD-WAN rule ID 1 is set to lowest cost (SLA) mode.
Answer: A,C
NEW QUESTION # 25
Refer to the exhibit.
The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths. However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths.
Based on the exhibit, which three settings must the administrator configure inside each BGP neighbor group so spokes can learn other spokes prefixes and their additional paths? (Choose three.)
- A. Enable soft-reconfiguration
- B. Enable route-reflector-client
- C. Set adv-additional-path to the number of additional paths to advertise
- D. Set additional-path to send
- E. Set advertisement-interval to the number of additional paths to advertise
Answer: B,C,D
NEW QUESTION # 26
Refer to the exhibit.
The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device?
(Choose two.)
- A. ibgp-multipath is disabled.
- B. additional-path is enabled.
- C. Each BGP route is three hops away from the destination.
- D. You can run the get router info routing-table database command to display the additional paths.
Answer: B,D
NEW QUESTION # 27
Refer to the exhibits.
Exhibit A
Exhibit B
Exhibit A shows the SD-WAN performance SLA configuration, the SD-WAN rule configuration, and the application IDs of Facebook and YouTube. Exhibit B shows the firewall policy configuration and the underlay zone status.
Based on the exhibits, which two statements are correct about the health and performance of port1 and port2? (Choose two.)
- A. The performance is an average of the metrics measured for Facebook and YouTube traffic passing through the member.
- B. FortiGate is unable to measure jitter and packet loss on Facebook and YouTube traffic.
- C. Non-TCP Facebook and YouTube traffic are not used for performance measurement.
- D. FortiGate identifies the member as dead when there is no Facebook and YouTube traffic passing through the member.
Answer: A,C
Explanation:
Study Guide 7.0, pages 88 - 89.
Study Guide 7.2, pages 103 - 104.
Another comment said "because without using application Control on the firewall policy, SDWAN can't work" but there is a app control "default" defined on config.
NEW QUESTION # 28
Refer to the exhibit.
Based on the output, which two conclusions are true? (Choose two.)
- A. Entry 1(id=1) is a regular policy route.
- B. There is more than one SD-WAN rule configured.
- C. The all_rules rule represents the implicit SD-WAN rule.
- D. The SD-WAN rules take precedence over regular policy routes.
Answer: A,B
NEW QUESTION # 29
Refer to the exhibits.
Which conclusion about the packet debug flow output is correct?
- A. The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- B. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- C. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.
- D. The packet size exceeded the outgoing interface MTU.
Answer: B
Explanation:
In a Per-IP shaper configuration, if an IP address exceeds the configured concurrent session limit, the message "Denied by quota check" appears. SD-WAN 7.0 Study Guide page 287
NEW QUESTION # 30
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- B. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.
- C. XAuth is enabled as an additional level of authentication, which requires a username and password.
- D. A peer ID is included in the first packet from the initiator, along with suggested security policies.
Answer: A,C
NEW QUESTION # 31
Refer to the exhibits.
Exhibit A
Exhibit B
Exhibit A shows the source NAT (SNAT) global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two actions does FortiGate perform on existing sessions established over port2, if the administrator increases the static route priority on port2 to 20? (Choose two.)
- A. FortiGate performs a route lookup for the original traffic only.
- B. FortiGate updates the gateway information of the sessions with SNAT so that they use port1 instead of port2.
- C. FortiGate continues routing the sessions with no SNAT, over port2.
- D. FortiGate flags the sessions as dirty.
Answer: B,D
NEW QUESTION # 32
Refer to the exhibits.
Which two statements about the IPsec VPN configuration and the status of the IPsec VPN tunnel are true? (Choose two.)
- A. FortiGate does not install IPsec static routes for remote protected networks in the routing table.
- B. Dead peer detection is disabled.
- C. FortiGate facilitated the negotiation of the T_INET_1_0_0 ADVPN shortcut over T_INET_1_0.
- D. The phase 1 configuration supports the network-overlay setting.
Answer: A,D
NEW QUESTION # 33
Refer to the exhibit.
Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change? (Choose two.)
- A. FortiGate flushes all sessions.
- B. FortiGate terminates the old sessions.
- C. FortiGate does not change existing sessions.
- D. FortiGate evaluates new sessions.
Answer: C,D
Explanation:
FortiGate not to flag existing impacted session as dirty by setting firewall-session-dirty to check new. The results is that FortiGate evaluates only new session against the new firewall policy.
NEW QUESTION # 34
Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.
What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?
- A. You must disable idle-timeout.
- B. You must enable net-device.
- C. You must set ike-version to 1.
- D. You must enable auto-discovery-sender.
Answer: B
NEW QUESTION # 35
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
- A. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
- B. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
- C. A factory reset performed on FortiGate.
- D. The zero-touch provisioning process has completed internally, behind FortiGate.
- E. The FortiGate cloud key has not been added to the FortiGate cloud portal.
Answer: D,E
NEW QUESTION # 36
Refer to the exhibit.
Based on the exhibit, which two statements are correct about the health of the selected members? (Choose two.)
- A. FortiGate can offload the traffic that is subject to passive monitoring to hardware.
- B. FortiGate passively monitors the member if TCP traffic is passing through the member.
- C. After FortiGate switches to active mode, FortiGate never fails back to passive monitoring.
- D. During passive monitoring, FortiGate can't detect dead members.
Answer: B,D
NEW QUESTION # 37
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set source 100.64.1.1.
- B. Set priority 10.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set cost 15.
Answer: B,D
NEW QUESTION # 38
Refer to the exhibits.
Exhibit A
Exhibit B -
Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status.
The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule.
Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?
- A. The traffic will be routed over T_INET_0_0.
- B. The traffic will be routed over T_INET_1_0.
- C. The traffic will be routed over T_MPLS_0.
- D. The traffic will be load balanced across all three overlays.
Answer: C
NEW QUESTION # 39
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
- A. diagnose sys sdwan sla-log
- B. diagnose sys sdwan health-check
- C. diagnose sys sdwan log
- D. diagnose sys sdwan intf-sla-log
Answer: A
Explanation:
SD-WAN 7.2 Study Guide page 321 You can view the stored member metrics by running the diagnose sys sdwan sla-log command. Note that you must include the name of the performance SLA followed by the member configuration index number. To display the SLA logs per interface, you run the diagnose sys sdwan intf-sla-log command.
NEW QUESTION # 40
......
The Fortinet NSE7_SDW-7.0 exam consists of multiple-choice questions, and candidates have two hours to complete it. The passing score is 70%, and the exam is available in several languages, including English, French, German, Japanese, and Spanish. Candidates must register for the exam through the Fortinet website and pay a fee to take the exam.
Free NSE7_SDW-7.0 Exam Braindumps Fortinet Pratice Exam: https://www.exam4free.com/NSE7_SDW-7.0-valid-dumps.html
Instant Download NSE7_SDW-7.0 Free Updated Test Dumps: https://drive.google.com/open?id=1iGx-txYbvsHWSERFqtqIEll6VrcJHg7b
